Automate your laboratory processes with our modular dosing system
We develop, test and supply a ready-to-fit complete solution comprising manifold duct plate, dosing valves and nozzles together with a suitable kinematic system, all in line with your requirements. For safe, precise and compact handling of liquids in the laboratory.
You can then:
- Dispense fluids with a dispensing valve and extract them in a controlled way
- Vary the control for pressure and vacuum.
Modular dispensing system
Dispense head VTOE
- VTOE-1-1 for single-channel dispensing
- VTOE-4-4 for possible combinations
- Up to 8 dispense heads on a rail or retaining plate
- Ideal for manufacturing thinners, adding nutrient solutions, dispensing reagents
- Parallel dosing of different fluids and fill quantities
- Available with manifold duct plate in high-quality PEEK or transparent PC
Dispense head VTOE-8-8-C with cover
- 8-channel
- Optimally adapted to microplates
- Very high throughput
- Individual control of the valves permits the channels to be coordinated for maximum precision.
Solenoid isolation valves VODA
With flanged connection
- Nominal sizes: 0.4 ... 1.0 mm
- 2/2 or 3/2-way valve
- Ideal for dispensing small fluid volumes
With threaded connection
- Nominal width: 2.0 ... 6.0 mm
- Optimum for switching cleaning fluids and rinsing processes, for example
Pressure regulators and flow control valves: pumping liquids using air pressure
Pressure regulator VEAA/VEAB
- 3/3-way valve including pressure sensor and control electronics
- Pressure regulation for the supply pressure range from vacuum up to 6 bar
- Short response times of less than 10 ms
- Highly accurate pressure regulation
- Very low power consumption
- Without switching noises
Proportional pressure regulator terminal VEMA
- 8-channel pressure regulator with 8 independent valves VEMC
- Energy-efficient operation in the smallest of spaces thanks to piezo technology
- CAN bus control