Festo Singapore Training Details
Course Overview

Certificate in Precision Engineering (Manufacturing & Production)

HN21  Operate and setup hydraulic systems

This course provides the participant with basic knowledge of the construction and function of hydraulic and electric components as well as to develop the ability to read, design and construct simple hydraulic circuits.


SN41  Operate electrical sensors

This course provides the participant with knowledge of operating principles of the various type of proximity sensors used for handling and processing technology, including the analysis.

 

Higher Certificate in Precision Engineering (Manufacturing & Production)

Full Higher Certificate in Precision Engineering could be attained if all 4 core modules and any 4  of the specialisation electives modules are completed.

 Core modules:

GN01  Apply quality systems

This course provides the participant with the fundamental knowledge and skill in planning and carrying out their daily work to meet quality system requirements.

GN02  Apply teamwork in the workplace

This course provides the participant with the fundamental knowledge and skills in participating in work teams and how to apply them to the workplace.

GN03  Apply workplace safety and health policy

This course provides the participant with the fundamental knowledge and skill in carrying out planning of daily work to meet WSH requirements, identifying and monitoring the hazards, complying with WSH requirements and implementing risk control.


GN04 Apply continuous process improvement techniques

 This course provides the participant with the fundamental knowledge and skill in applying continuous process improvement techniques and be able to put it into practice at their workplace.

 

Specialisation Elective modules:

PN11  Understanding pneumatic technology in automation

This course provides the participant with an understanding of the construction and function of pneumatic and electric components in automation. Participants will also be able to read, design and construct simple pneumatic circuits.


PN12  Total preventive maintenance (TPM) of pneumatic system

This course provides the participant with the knowledge of understanding pneumatic systems from the maintenance perspective, a systematic approach to maintenance, troubleshooting and design of pneumatic circuits is practised.


HN22  Maintain and repair hydraulic systems

This course provides the participant with the knowledge of hydraulic control systems, a systematic approach to maintenance, troubleshooting and design of hydraulic circuit is practised. 


EN31  Operate programmable logic controllers (PLC)

This course provides the participant with the knowledge of the characteristics of Programmable Logic Controllers (PLC) and able to set-up an operate it. The participant will also do some basic PLC programming using ladder diagrams.


EN32  Programming a programmable logic controllers (PLC)

This course provides participants with knowledge of construction and operation of a PLC and be able to translate control tasks into operational PLC programmes. The participant would be able to write and simulate the control system based on IEC 61131-3standards.

 

Advanced Certificate in Precision Engineering (Manufacturing & Production)

HN23  Design hydraulic systems

This course provides the participant with a wider knowledge of complex hydraulic and electro-hydraulic control systems as well as to develop ability to design, assemble and operate the controls which enable the participant to read and assemble circuits with additional conditions.


PN13  Advanced design of pneumatic systems for automation

This course provides the participant with a wide range of complex pneumatic and electro-pneumatic control systems as well as to develop ability to design, assemble and operate the controls. The participant will be able to read and assemble circuit with additional condition.

 

For more details