Our didactic representatives can help you select the right industrial control options for your requirements. 3 Industrial Control Technology > Data Acquisition and Control > PLC EasyPort USB Interface for Measuring, Open- and Closed-Loop Control Connection of software/simulation with actual training equipment/ all PLCs The EasyPort USB is used for bidirectional transmission of process signals between a real low-voltage control process and a PC. The connection to the automation equipment is via standard SysLink connectors. Input and output signals can thus be read into and output from a PC. So that EasyPort can adapt to different situations, we have developed software for the device drivers with a graphical user interface, through which connections can be made. The possible uses of EasyPort USB are diverse: EasyPort USB 548687 Scope of delivery – EasyPort USB/EasyPort USB 19” – 24 V connecting cable on 4 mm safety plugs – USB cable – CD-ROM: EasyVeep, EasyOPC driver, datasheet, ActiveX control, examples of control using LabVIEW Also order: For EasyPort with a real process or SimuBox: I/O data cable with SysLink connectors (IEEE 488) at both ends, 2.5 m 34031 Analog cable, parallel, 2 m 529141 For EasyPort with a real process or SimuBox: I/O data cable with SysLink connectors (IEEE 488) on both ends, crossover 167106 For EasyPort, freely wireable, with any PLC: I/O data cable with SysLink connector IEEE 488 and bare cable-end sleeves 167122 For EasyPort with an EduTrainer: I/O data cable, crossover, with terminal socket, 0.3 m 167197 For EasyPort with a real PLC or SimuBox: Analog cable, crossover, 2 m 533039 CODESYS starter kit with CECC-LK and EasyPort USB 8024001 Universal connection unit, digital (SysLink) 162231 Quick-Fix screw adapter 549806 EasyPort USB 19” 8021637 – Controlling a real process with a controller running on the PC – Controlling a simulated process model with a real PLC – Control of a real process, the control runs on the PC – Recording and evaluating measured values from a real process A maximum of 8 EasyPort USB modules can be interconnected via a USB hub or via USB ports on a PC. It should be noted that the addresses of the modules are different. Numerous practical process models can be controlled using any PLC using EasyPort and the EasyVeep simulation software included in scope of delivery. Technical data – 24 V power supply via separate screw terminals or via SysLink connectors – Interface to PC (galvanically isolated): USB 2.0, RS 232. Up to 4 modules can be connected via a USB hub. Transmission speed: 115 kbaud – Analog interface: sub-D 15-pin socket, 12 bit resolution, 4 analog inputs, 2 analog outputs, sample frequency 0.5 kHz – Digital interface: 16 digital inputs, 16 digital outputs on 2 x 24-pin Centronics sockets with 8 digital inputs each (24 V), 8 digital outputs (24 V). 24 V power supply. Digital signals represented by LEDs. – Large LCD display, display of channel, unit, trend and measured value (4 digits). Selection of the channel to be displayed and the units via keys. – Controllable via FluidSIM, FluidLab PA (Closed-Loop, Process, Water Management...), CIROS, Festo Didactic EzOPC, LabVIEW, C++, Visual Basic, Matlab.
RkJQdWJsaXNoZXIy MzE0OTAwNw==